![]() Elgato and Blackmagic Ultra Studio does not have loopback connection ESPECIALLY MAGWELL fills that of External Monitor viewing and acting as Computer Web Cam for Zoom etc. Enter Youtube/Facebook Stream ID on the ATEM Mini Pro software control directly for live stream Connect Magwell USB connection to a Computer USB for Zoom ConferenceĦ. Connect Magwell HDMI Plus Loopback HDMI to a Monitor HDMI for output viewing including multi-viewĥ. Connect HDMI OUT to a Camera Capture Device like Magwell HDMI Plus (best choice), or Elgato Cam Link or Black Magic Ultra Studio Mini RecorderĤ. Connect External Hard Disk to USB-C for recordingģ. Connect ATEM MINI PRO to internet using EthernetĢ. View out put on a Monitor (multi-view or otherwise)ĭo the following to achieve all the above at the same time:ġ. Stream Live to Youtube or Facebook (one of them directly and many using third party distribution)Ĥ. If you would like to use ATEM MINI PRO to do the following simultaneously:ģ. Not sure where to go from here, so I'd really appreciate any ideas or suggestions. In Skype camera settings, it doesn't see it at all: "No device found." Please connect a camera and verify correct camera permissions in your browser." In OBS, the ATEM Mini is not recognized and doesn't show up as an option when setting up a new Video Capture Device.įacebook Live's camera dropdown shows "Blackmagic Design (1edb:be49)", but when I select it, it says "Unable to find camera. From there I can control the switcher without issue. I'm able to control the switcher perfectly from the ATEM Software Control program, though whenever I first open the program, I get "No device connected" displayed for a few seconds before the control panel interface appears. I've tried connecting the ATEM Mini to my computer using two different USB-C to USB-A cables - one USB 3.1 and one USB 2.0 - using different 2.0 and 3.0 ports on my computer. I have two cameras going into the ATEM Mini, both showing fine and switching/cutting properly on the HDMI-connected external monitor. I can't get OBS and various other programs to properly recognize the ATEM Mini USB "webcam".įor background: I've read the relevant sections of the manual as far as set-up, connecting to computer, etc, and I've installed the Blackmagic "ATEM Switchers 8.1 Update" software from. EDIT: Solution was to switch "Allow apps to access your camera" to ON in "Camera privacy settings" (Windows 10).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |